Masonry repair
Sweep & inspection
Caps & crowns
Flue relining
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Reno
If smoke is rolling back into the room, the crown is crumbling, or the brick face is flaking off, you need a chimney repair plan built for Reno’s particular housing stock, not a generic patch. We work on chimneys only, every day, in a valley where a lot of homes still heat with wood and the flues were never set up to handle it. That means we’ve seen the cracked clay tiles, the undersized stacks, and the wind-torn caps that come with the territory. Call (844) 543-7293 and we’ll book an inspection. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Reno Homeowners Call Reno Chimney Cleaning for Chimney Repair
Reno has plenty of people who’ll clean a chimney. Fewer who’ll tell you plainly what the camera shows and what can wait. That’s the difference we lean on. Our technicians have up to 10 years of experience, every one of them trained on chimney-specific diagnostics rather than treating flues as a side job between roof patches and gutter work.
We inspect before we recommend. Nothing gets quoted without a Level 2 camera inspection, and the photo report is yours to keep, so you can see the crack in the liner or the gap in the flashing for yourself instead of taking our word on a several-thousand-dollar job. Our customers in Reno tend to call us back for the annual sweep because the same company handles sweep, inspection, and repair, so you’re not coordinating three contractors for one chimney.
We know how this valley behaves. The Washoe Zephyr rolls in most afternoons and finds every weak cap and every bad draft the same day the wind picks up. Homes near downtown and around the university have their own quirks. When we quote a repair in Reno, we’re quoting for what those conditions actually do to a chimney over a cold winter.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Chimney Masonry Repair in Reno
Chimney Masonry Repair in Reno usually means the crown, the brickwork, or the firebox has taken enough freeze-thaw cycling to start failing, and it’s showing up as loose mortar joints, a crumbling crown, or brick faces flaking off. The fix depends on what’s actually failing. Crumbling mortar joints get ground out and repointed. Spalling brick gets replaced where the face has blown. A cracked crown gets rebuilt so water runs off it instead of soaking into the masonry below.
Reno’s day-night temperature swings are hard on masonry. A crown that looked fine in October can be a sieve by February, and the water it lets in is what drives most of the spalling and repointing work we do. A typical tuckpointing or repointing job in Reno runs $600 to $1,800 depending on how much of the stack is involved. Crown repair is usually $350 to $900. Full chimney rebuilding, where the upper courses have to come down and go back up, runs $3,000 to $8,000 or more. The written estimate sets the final price.
Repointing vs. Rebuilding
Repointing saves the brick you already have by replacing the mortar that’s failed. Rebuilding is for when the brick itself has gone soft or the stack has moved, and no amount of mortar will hold it. We test the masonry before recommending either, and we’ll tell you when repointing is enough.
Waterproofing the Masonry
Reno’s high-desert sun bakes the south and west faces of a chimney while the other side stays cold, and that’s a recipe for cracked brick over time. A breathable masonry waterproofing goes on after the mortar repairs are done so it seals the brick without trapping moisture inside.
Chimney Cap Installation in Reno
Chimney Cap Installation in Reno is one of the cheapest repairs that prevents some of the most expensive damage, and it’s the piece most often missing after a windy season. A cap keeps rain and snow out of the flue, stops birds and squirrels from nesting in the stack, and gives the spark a place to die before it hits the roof. It also breaks the wind across the top of the flue, which is what keeps the Washoe Zephyr from pushing smoke back down the chimney.
We fit caps in stainless and in copper. Famco and Copperfield caps are what we reach for most often, and the right size and mesh depend on the flue and the appliance below it. A single-flue cap runs about $250 to $550 installed in Reno. Multi-flue and custom-fit caps are typically $500 to $1,200. If your cap is rusted through, bent, or missing entirely after a gusty stretch, that’s a same-week booking.
Matching the Cap to the Flue
An undersized cap on a big flue chokes the draft. An oversized one lets rain in around the edges. We measure the flue before we order, and we check the draft after the cap goes on so you know the smoke will leave the way it should.
When a Cap Is Not Enough
Sometimes the smoke problem isn’t the cap at all. If the flue is undersized or unlined for solid fuel, a new cap just moves the problem around. That’s when we step back and look at the whole stack.
Trusted Brands We Service in Reno
We work with a short list of professional-grade brands because the material under the cap is what decides how long the repair lasts. Olympia Chimney and DuraFlex liner systems cover most relining work, HeatShield handles liner resurfacing where the existing flue can be saved, and Famco and Copperfield cover caps and ventilation. We don’t claim to stock every part on a shelf in Reno, but we can source what your chimney needs, and turnaround is quick since we’re working with brands the trade uses every day. The right liner system for your flue is matched to what the camera shows, not to whatever’s easiest to order.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Reno Homes
The one problem that comes up again and again in Reno’s older core is a wood stove or insert vented into a flue that was never lined for solid fuel. In attached or tightly built properties that undersized stack is sometimes shared with, or immediately adjacent to, a neighbor’s appliance. That’s a cross-contamination risk, and fixing it means correcting flue sizing and separation, not just patching the firebox.
- Cracked or spalling clay-tile liners. Older Reno homes often still have the original clay-tile flue, and it cracks with age until heat and creosote can reach the framing. A brush-and-go cleaning hides the problem until a Level 2 camera inspection finds it.
- Wind-driven downdrafts and missing caps. The Washoe Zephyr finds every rusted or absent cap and pulls smoke and creosote odor back into the living space. A cap that was never replaced after wind damage is usually the culprit.
- Informal wood-heat retrofits near downtown and the university. Decades of do-it-yourself wood-heat installs left stoves vented into undersized or unlined flues. Where those stacks are shared with a neighbor’s appliance, both flues need separating and relining before either one is safe.
- Crumbling crowns and opened mortar joints. Reno’s freeze-thaw swings open up mortar joints and crack crown tops. The water that gets in is what drives the spalling and repointing work, so fixing the crown is usually the first order of business.
Here’s how this kind of job typically goes. A homeowner in a mid-century Reno ranch lights a wood stove on a cold Sierra morning and gets smoke rolling back into the room. A qualified local pro runs a Level 2 inspection with a camera, checks draft against the valley’s downdrafts, and usually restores the stack with a correctly sized stainless liner such as a DuraFlex or Olympia Chimney system, a new cap, and masonry or crown repairs as needed, then confirms the damper and smoke chamber are clear of creosote before signing off. In attached properties that same visit often turns up a neighbor’s appliance venting into the shared stack, and that has to be separated and re-lined.
Pricing for Chimney Repair in Reno, NV
Chimney repair in Reno isn’t a flat-rate trade, but the ranges are knowable. Repointing and tuckpointing typically run $600 to $1,800 depending on how much of the stack is involved. Crown repair is about $350 to $900. A single-flue cap installed runs $250 to $550, with multi-flue and custom-fit caps at $500 to $1,200. Flashing repair is usually $300 to $800. Where the liner has failed and a full reline with a DuraFlex or Olympia Chimney system is the right call, that’s typically $2,500 to $6,500 depending on length, diameter, and whether the old liner has to come out first. Full chimney rebuilding runs $3,000 to $8,000 or more. The estimate is free and the written estimate sets the final price. If the camera shows the work can safely wait a season, we’ll tell you that too.
We Also Serve Cities Near Reno
Our chimney repair service covers Reno and the towns around it, including Reno-area communities like Golden Valley, Sun Valley, Mogul, and Lemmon Valley. If you’re just outside the city and heating with wood, the same high-desert winter and the same windy afternoons are working on your chimney. Call and we’ll book a visit.
Serving Reno, NV – Our Local Coverage Area
We serve Reno and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Repair in Reno
Masonry repair covers the crown, the brickwork, the mortar joints, and the firebox itself, and the crown is usually where it starts. On a Reno chimney, the crown takes the freeze-thaw swings and the sun on the exposed faces, so it cracks first and lets water into the masonry below. Repointing, spall replacement, crown rebuilding, and firebox repair all fall under it. Call (844) 543-7293 for an exact quote. Estimates are free.
We book repair visits into the next available opening, so the lead time is usually short in Reno. Same-day work is often possible when the schedule allows. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside those dispatch hours is booked into the next opening.
Yes, we cover Reno from the older core near downtown and the university out to the south and northwest subdivisions. That includes the mid-century ranch homes and the 1990s and 2000s tract builds, which have different chimney issues because they were built in different eras. Call and we’ll confirm your area.
Yes, and in Reno’s denser older housing that’s often the real repair. A stove or insert vented into a flue that was never lined for solid fuel is a common find, and when that stack is shared with or next to a neighbor’s appliance, the flues have to be separated and relined. We can work with your insurer where that applies. Call (844) 543-7293 to book an inspection.
Generally the ranges are similar to Sparks and the surrounding towns, since the same materials and the same labor market apply. Repointing runs $600 to $1,800, crown repair $350 to $900, caps $250 to $550, and a full reline typically $2,500 to $6,500. The written estimate sets the final price. Call (844) 543-7293 for an exact quote. Estimates are free.
Chimney repair done once and done right costs less than the water damage and creosote problems that come from putting it off. Our chimney repair team handles sweep, inspection, and repair under one roof, so you get one diagnosis and one plan. Call (844) 543-7293 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Reno Chimney Cleaning.